Installation Manual For Your MistBuster 500 Mist Collector from
BreathePureAir
Inspection
The MistBuster air cleaner should be checked for any
shipping damage that may have occurred during shipping. Any damage
should be noted and the carrier notified immediately.
Tools & Equipment Required
The following is a list of tools that would be needed for
typical installations:
-
reciprocating saw
-
drill
-
screwdriver
-
pipe wrenches
-
fork truck or crane
Planning the Installation
The MistBuster mist collector should
be located with consideration for convenience of maintenance and electrical
compartment access.
The filter access door on the MistBuster should
not be obstructed. You need a minimum of 16" clearance in front of the
filter access door.
The side access cover (right hand) should also
be accessible, if possible. This will make it easier to access the
electrical components such as the switches and high voltage power supply.
Mount the MistBuster as far from the chip
conveyor opening as possible. This will minimize the amount of clean
outside shop air from being drawn into the enclosure.
Direct Mount
Click for Instructions
Duct Installation
Click for Instructions
Machine Mount
Click for Instructions
Ceiling Mount
Click for Instructions
Pedestal Mount
Click for Instructions
Drain Mount
Click for Instructions
Electrical Installation
Click for Instructions
Start Up
Click for Instructions
Routine Maintenance
Click for Instructions
HEPA Filter Option
Click for Instructions
Troubleshooting
Click for Instructions
| 
